an indirect method and equipment for temperature monitoring and control
Clicks: 253
ID: 168865
2015
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Steady Performance
30.2
/100
253 views
43 readers
AI Quality Assessment
Not analyzed
Readership in this journal
SteadyRanked #53 of 91 articles by views in JMIR mHealth and uHealth
Most read
Least read
Bar heights use a square-root scale.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
A new temperature control method for a metallic filament used at high temperature values is proposed
by the authors in this paper. The filament used is heated by a switch mode power supply built around
a step-down converter. The method uses a microcontroller that implements the temperature control
algorithm and also the power supply control loops. The temperature is controlled using a proposed
new algorithm based on the output current and output voltage measurements of the power supply already
available for implementing the average current mode control. In this way the resistance of the filament
can be determined and controlled in a resistance feedback loop. The proposed algorithm will control the
resistor value corresponding to the required temperature. The reference resistance value is computed
based on the temperature-resistance characteristic of the filament each time a new temperature is
introduced in dedicated computer software on a PC. The value is transmitted to the microcontroller
via USB interface. The temperature control algorithm and experimentally results are presented in
detail in the paper.
| Reference Key |
r.2015advancesan
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;ETZ, R.;PETREUS, D.;FRENTIU, T.;PATARAU, T.;ORIAN, C. |
| Journal | JMIR mHealth and uHealth |
| Year | 2015 |
| DOI |
10.4316/AECE.2015.04012
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.