[1] Epidermal mechano-acoustic sensing electronics for cardiovascular diagnostics and human-machine interfaces

[2] new surface-treatment technique of concrete structures using crack repair stick with healing ingredients

[3] probabilistic dynamics for integrated analysis of accident sequences considering uncertain events

[4] investigation of a random-fractal antenna based on a natural tree-leaf geometry

[5] effect of water vapor and surface morphology on the low temperature response of metal oxide semiconductor gas sensors

[6] simple floating voltage-controlled memductor emulator for analog applications

[7] a new controller for fes-assisted sitting down in paraplegia

[8] signal construction-based dispersion compensation of lamb waves considering signal waveform and amplitude spectrum preservation

[9] design, construction, and modeling of a 252cf neutron irradiator

[10] models of printed boards for solderless mounting of electronic components by foil perforation method

[11] optical biosensors based on photonic crystals supporting bound states in the continuum

[12] high dynamic torque capability with efficiency optimization control of induction motor drives

[13] effect of acid hydrolysis conditions on the properties of cellulose nanoparticle-reinforced polymethylmethacrylate composites

[14] synthesis methods of carbon nanotubes and related materials

[15] crystallization of electrodeposited germanium thin film on silicon (100)

[16] a compact tri-band printed antenna for mimo applications

[17] information approach to safety analysis of signalling systems

[18] the combined effect of signal strength and background traffic load on speech quality in ieee 802.11 wlan

[19] software solution for a renewable energy microgrid emulator

[20] variation of shrinkage strain within the depth of concrete beams

[21] testing of high frequency electromagnetic field in the environment in the vicinity of base stations and radio and tv transmitters

[22] multi-response parameter interval sensitivity and optimization for the composite tape winding process

[23] 3d uwb magnitude-combined tomographic imaging for biomedical applications. algorithm validation

[24] resource allocation for vertical sectorization in lte-advanced systems

[25] influence of the conditioning method for pre-sintered zirconia on the shear bond strength of bilayered porcelain/zirconia

[26] a fuzzy simulation model for military vehicle mobility assessment

[27] compact antenna with frequency reconfigurability for gps/lte/wwan mobile handset applications

[28] characterization of wood derived hierarchical cellulose scaffolds for multifunctional applications

[29] south-eastern anatolia project (gap) factor and energy management in turkey

[30] microstrip folded dipole antenna for 35 ghz mmw communication

[31] on the effects of hot forging and hot rolling on the microstructural development and mechanical response of a biocompatible ti alloy

[32] about eddy currents in induction melting processes

[33] commercial coffee wastes as materials for adsorption of heavy metals from aqueous solutions

[34] carbon nanotube electron emitter for x-ray imaging

[35] aplikasi verifikasi wajah untuk absensi pada platform android dengan menggunakan algoritma fisherface

[36] titanium as a reconstruction and implant material in dentistry: advantages and pitfalls

[37] design aspects of printed monopole antennas for ultra-wide band applications

[38] design of the robust synchronous generator stator voltage regulator based on the interval plant model

[39] thick film fail-safe resistors

[40] comparative analysis of the dalat nuclear research reactor with heu fuel using srac and mcnp5

[41] a comparative study of the sintering behavior of pure and manganese-substituted hydroxyapatite

[42] study the efficiency of single crystal cdte/zncds solar cell at various temperatures and illumination levels

[43] experimental research of harmonic spectrum of currents at traction drive with pmsm

[44] characteristics and possibilities of computer program for fast assessment of primary frequency control of electric power interconnections

[45] anisotropic-cyclicgraphene: a new two-dimensional semiconducting carbon allotrope

[46] optical properties and plasmonic performance of titanium nitride

[47] influence of the composition, structure, and physical and chemical properties of aluminium-oxide-based sorbents on water adsorption ability

[48] local positioning services on ieee 802.11 networks

[49] study of the temperature turbulences effect upon optical beam in atmospheric optical communication

[50] non-canonical spectral decomposition of random functions of the traction voltage and current in electric transportation systems

[51] revisiting groundwater chemical processes in a rapidly urbanizing basin

[52] validation and application of the thermal hydraulic system code trace for analysis of bwr transients

[53] broadband vertically/horizontally dual-polarized antenna for base stations

[54] technology of polymer microtips’ manufacturing on the ends of multi-mode optical fibers

[55] a novel technique for steganography method based on improved genetic algorithm optimization in spatial domain

[56] three-dimensional printed pla and pla/pha dumbbell-shaped specimens: material defects and their impact on degradation behavior

[57] mechanical properties of nylon harp strings

[58] impact of the gate width of al0.27ga0.73n/aln/al0.04ga0.96n/gan hemt on its characteristics

[59] golden sine algorithm: a novel math-inspired algorithm

[60] experimental characterization and correlation analysis of indoor channels at 15 ghz

[61] ti-doped zno thin films prepared at different ambient conditions: electronic structures and magnetic properties

[62] performance comparison of thin and thick film microstrip rejection filters

[63] static simulation of a linear switched reluctance actuator with the flux tube method

[64] analysis of electrical energy consumers operation in the heating plant with proposal of energy savings measures

[65] suppression of cross-polarization of the microstrip integrated balun-fed printed dipole antenna

[66] dynamic shear deformation and failure of ti-6al-4v and ti-5al-5mo-5v-1cr-1fe alloys

[67] capability study of ti, cr, w, ta and pt as seed layers for electrodeposited platinum films on γ-al2o3 for high temperature and harsh environment applications

[68] implementación de un sistema dil/metpc con labview para ensayos a transformadores; implementation of embedded system dil/netpg with labview for test to transformers

[69] design of a printed dipole antenna array for a passive radar system

[70] compact multiband planar fractal cantor antenna for wireless applications: an approach

[71] a compact low-permittivity dual-layer ebg structure for mutual coupling reduction

[72] challenges and strategies in the synthesis of mesoporous alumina powders and hierarchical alumina monoliths

[73] application of coupled fixed point technique in solving integral equations on modified intuitionistic fuzzy metric spaces

[74] fenomena korosi zirkaloy-2 dan zirkaloy-4 dalam media larutan nacl secara elektrokimia

[75] synthesis and drug delivery application of thermo- and ph-sensitive hydrogels: poly(β-cd-co-n-isopropylacrylamide-co-iam)

[76] sem analysis of the interfacial transition zone between cement-glass powder paste and aggregate of mortar under microwave curing

[77] a dspic implementation of a sliding mode strategy for a sepic converter

[78] physisorbed polymer-tethered lipid bilayer with lipopolymer gradient

[79] modification of ordinary differential equations matlab solver

[80] on the statistical properties of nakagami-hoyt vehicle-to-vehicle fading channel under nonisotropic scattering

[81] oil-in-water self-assembled synthesis of ag@agcl nano-particles on flower-like bi2o2co3 with enhanced visible-light-driven photocatalytic activity

[82] training radial basis function neural network using stochastic fractal search algorithm to classify sonar dataset

[83] audible aliasing distortion in digital audio synthesis

[84] experimental results of bridgeless pfc boost converter

[85] tuning range and power handling analysis of dtc-based matching networks for reconfigurable high power rf circuits

[86] desulphurization of coals of different ranks in the presence of slimes by reverse flotation

[87] perspective of buried oxide thickness variation on triple metal-gate (tmg) recessed-s/d fd-soi mosfet

[88] http://www.tkea.com.ua/tkea/2008/6_2008/pdf/12.zip

[89] design of a 12-bit 200ms/s cmos sample-and-hold circuit

[90] probabilistic model for free-space optical links under continental fog conditions

[91] piezoelectric, mechanical and acoustic properties of knanbof5 from first-principles calculations

[92] a fatigue life prediction method based on strain intensity factor

[93] influence of column axial load and heat affected zone on the strength of aluminium column web in tension

[94] new current-mode bandpass filters using three single-output icciis

[95] improvement of small-signal stability of power system by controlling doubly fed induction generators of a large-capacity wind farm

[96] performansi motor induksi tiga phasa pada kondisi operasi satu phasa dalam perspektif neuro fuzzy analisis

[97] anisotropy of photopolymer parts made by digital light processing

[98] application of genetic algorithm to estimation of function parameters in lightning currents approximations

[99] cement kiln by-pass dust: an effective alkaline activator for pozzolanic materials

[100] performance-enhanced textured silicon solar cells based on plasmonic light scattering using silver and indium nanoparticles

[101] pegylated amine-functionalized poly(ε-caprolactone) for the delivery of plasmid dna