models of printed boards for solderless mounting of electronic components by foil perforation method
Clicks: 337
ID: 129467
2017
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Emerging Content
30.0
/100
337 views
51 readers
AI Quality Assessment
Not analyzed
Readership in this journal
EmergingRanked #4 of 26 articles by views in premiere educandum
Most read
Least read
Bar heights use a square-root scale.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
The paper presents models of printed circuit boards for an improved foil perforation method. The density of electrical connections of such printed circuit boards is estimated in comparison with circuit boards obtained using the methods of mounting in holes and surface mounting. The technological differences in the manufacture of printed circuit boards for the foil perforation method and the traditional method are considered.
| Reference Key |
a.2017tekhnologiyamodels
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;Yefimenko A. A.;Paliukh B. P. |
| Journal | premiere educandum |
| Year | 2017 |
| DOI |
10.15222/TKEA2017.4-5.03
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.