Path planning and kinematics simulation of surfacing cladding for hot forging die
Clicks: 270
ID: 65811
2015
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Popular Article
30.0
/100
270 views
28 readers
AI Quality Assessment
Not analyzed
Readership in this journal
PopularRanked #102 of 300 articles by views in matec web of conferences
Most read
Least read
Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 300 in total.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
During the course of their work, a variety of damage and failure of hot forging die occurs and seriously affect the service life. Multi-layer metal hot forging die with functionally graded material structure can effectively extend the service life. In this paper, According to the needs of strengthening forging cavity, the CAD model of surfacing forming center was designed. Based on technological requirements of surface cladding for die cavity, the coupled movement equation of weld torch was established, and the trajectory of welding positioner and Cartesian robot kinematics was solved. The weld torch path was planned, according to the typical methods used in plane welding, and the surfacing path data was extracted by the secondary development of UG/OPEN. Then the kinematics solver program, which can output the control function of motion simulation, was written in MATLAB to solve the kinematics equation. Finally, in UG NX7.5, the kinematics simulation model was built to verify the correctness of mathematical model and the rationality of welding path planning. The above studies can provide a technical support for the die repair and manufacturing of a multilayer metal forging die.
| Reference Key |
huajun2015pathmatec
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | Huajun, Wang;Wanxia, Fu;Hengan, Ou;Xuan, Tang; |
| Journal | matec web of conferences |
| Year | 2015 |
| DOI |
DOI not found
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.