High hydraulic diffusivities revealed from in-situ measurements in the Delaware Basin: Implications for Coulomb Stressing and Induced Seismicity

Clicks: 3
ID: 316978
2026
Free PDF
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This article has not been analysed, so there is no overall score — reader engagement is measured and shown alongside.
AI Quality Assessment
Not analyzed
Readership in this journal
Steady

Ranked #175 of 222 articles by views in geophysical journal international

Most read Least read

Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 222 in total.

Mint this article as an NFT
Not yet minted

Create a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.

5 SUSD one-off · no wallet required
Sign in to mint
Abstract
Abstract Seismicity rates in west Texas and southeast New Mexico have increased over the last nine years and are in large part driven by subsurface wastewater disposal associated with oil-gas operations. Injection-induced seismicity is often explained as the result of fault weakening from fluid pressurization. However, fluid injection also induces poroelastic stresses from fluid-rock coupling, which in some cases are larger than the perturbations induced from pore pressure alone. In this work, we model in-zone changes in pore pressure and poroelastic stressing along four major fault zones that have hosted moderate-large ML 4 – 5 earthquakes in the Delaware Basin (DB) of west Texas. We leverage high-quality downhole pore-pressure measurements to constrain the in-situ hydraulic diffusivity and storativity. The data show that the deep injection interval has a storativity of ∼ 5×10−5 and a diffusivity between 23-65 m2/s, suggesting that this interval can pressurize rapidly and transmit fluid pressure efficiently. We view these as local hydraulic properties and use an ensemble modeling approach that accounts for a large range in diffusivities and storativities to model changes in Coulomb Failure Stresses (CFS). Our 2D fully coupled poroelastic models show that deep subsurface fluid injection can induce between ∼1-1000 kPa in CFS along basement rooted faults that penetrate the injection interval, with the largest values occurring in models that use the hydraulic properties inferred from our in-situ measurements. However, the induced changes in CFS are much smaller (∼ 20-30 kPa) when averaging over a large range in hydraulic properties. Irrespective of the model parameterization, the in-zone perturbations in CFS are dominated by changes in pore pressure, even at distances as far as 20-30 km from the nearest injection source. Our results highlight the importance of obtaining in-situ poromechanical measurements and indicate that such high-resolution measurements are critical to understanding subsurface stressing associated with fluid injection.
Reference Key
openalex_W7164305620 Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors David Bolton, William Curry, Jamie Rich, Lei Jin, Katie Smye, Peter Hennings
Journal geophysical journal international
Year 2026
DOI
10.1093/gji/ggag226
URL
https://doi.org/10.1093/gji/ggag226
Keywords Keywords not found

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

Comments

No comments yet. Be the first to comment on this article.