Complex conductivity of clayey, opal-A-rich diatomites from the Fur Formation in NaCl and KCl solutions
Clicks: 1
ID: 314944
2026
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
0.0
/100
1 views
0 readers
AI Quality Assessment
Not analyzed
Readership in this journal
Ranked #161 of 219 articles by views in geophysical journal international
Most read
Least read
Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 219 in total.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
Summary The conductive and capacitive properties of rocks are influenced by the type and concentration of the electrolyte present in the pore water. Sodium (Na⁺) and potassium (K⁺) are common pore water cations in saturated sedimentary rocks. Their distinct physicochemical properties are expected to produce different frequency-dependent electrical dispersion when adsorbed onto mineral surfaces. We tested this expectation by using spectral induced polarization (SIP), a method sensitive to interfacial processes. Complex conductivity spectra (10–2 to 105 Hz) were measured on two clayey, opal-A-rich diatomite samples, saturated with either NaCl or KCl solutions. One sample was tested over a stepwise increase in molar concentration (5.4–53 mM), while the other was tested over a stepwise increase in bulk water conductivity (0.050–0.48 S/m). At equivalent molar concentration, the in-phase conductivity of a sample was ~20 per cent higher when KCl saturated than when NaCl saturated, reflecting the greater molar conductivity of K⁺. At matched bulk water conductivity, which required a ~20 per cent higher NaCl molarity than KCl molarity, in-phase conductivity was ~10 per cent higher when NaCl saturated. In both tests, the quadrature conductivity and normalized chargeability followed a lower trend in the KCl-saturated state than in the NaCl-saturated state. This relatively low polarization for the K+ saturated state can be attributed to a weaker hydration and more compact adsorption of K⁺ within the inner layer of the electrical double layer. Additionally, time-lapse monitoring of complex conductivity spectra indicates that chemical equilibration via diffusion is achieved within 72 hours for both electrolyte types. This relatively rapid ionic diffusion is consistent with estimates based on the intrinsic formation factor and probably reflects the high porosity of the diatomite (~0.7). These findings establish that pore-water cation identity (Na⁺ vs. K⁺) is a primary control on SIP-derived polarization parameters, and cation identity must therefore be incorporated into petrophysical models to avoid biased estimates of surface area, permeability, and hydrogeochemical state.
| Reference Key |
openalex_W7162430622
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | Ermis Proestakis, Ida Lykke Fabricius |
| Journal | geophysical journal international |
| Year | 2026 |
| DOI |
10.1093/gji/ggag202
|
| URL | |
| Keywords | Keywords not found |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.