A thin viscous sheet model for continental deformation
Clicks: 1
ID: 301776
1982
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
0.0
/100
1 views
0 readers
AI Quality Assessment
Not analyzed
Readership in this journal
Ranked #162 of 220 articles by views in geophysical journal international
Most read
Least read
Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 220 in total.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
For the purposes of describing its large-scale and long-term deformation, the continental lithosphere is regarded as a continuum, obeying a Newtonian or a power law rheology. The flow of a thin sheet of power law material overlying an inviscid substrate is studied under the assumption that vertical gradients of the horizontal velocity are negligible. A numerical model is used to investigate the deformation of such a sheet under conditions approximating those of continent—continent collision. The material flows in response to forces applied to its boundaries (for example, the indenting of one continent by another) and to forces in its interior arising from gradients in crustal thickness. The horizontal divergence of the flow produces changes in the crustal thickness and hence a time-dependent form to the flow itself. For a given set of boundary conditions, the flow depends on the stress exponent in the power law rheology, n, and on the Argand number Ar, which is a measure of the ratio between the stress arising from crustal thickness contrasts and the stress required to deform the material at the ambient strain rates. When the effective viscosity of the medium is very high (Ar→0), crustal thickness variations do not influence the flow. If the material is Newtonian (n=1), the deformation associated with an influx of material (approximating an indenter) is of much greater lateral dimension than the width of the indenter, whereas when material has a power law rheology (n=3, 5 are used), the deformation is confined to a region of lateral extent comparable to that of the indenter. As Ar increases, the forces arising from crustal thickness contrasts exert more influence on the flow, and the maximum crustal thickness that can be sustained by a given influx of material is related by a simple expression to the effective viscosity of the medium at the ambient strain rates. In the limit of a very weak medium (Ar > 10) the lithosphere is unable to sustain appreciable crustal elevation contrasts. The results of these numerical experiments show that systems in which the effective viscosities are such that the maximum deviatoric stresses are between 1 kbar and 100 bar have crustal thickness distributions comparable to that in the India—Asia collision zone. In addition, these systems have the characteristic that the forces arising from crustal thickness contrasts are great enough to produce net extension in the region of thick crust in front of the influx boundary, perpendicular to the direction of influx, as well as lateral movement away from the region of thickest crust. Observations of contemporary tectonics in Asia show phenomena very similar to these, in the active east—west extension of Tibet and the eastward motion of eastern Tibet.
| Reference Key |
openalex_W2110491183
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | Philip England, David R. McKenzie |
| Journal | geophysical journal international |
| Year | 1982 |
| DOI |
10.1111/j.1365-246x.1982.tb04969.x
|
| URL | |
| Keywords | Keywords not found |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.