Optimization of Machining Parameters for Minimization of Roundness Error in Deep Hole Drilling using Minimum Quantity Lubricant
Clicks: 214
ID: 30052
2016
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Steady Performance
78.1
/100
214 views
175 readers
Trending
AI Quality Assessment
Not analyzed
Readership in this journal
SteadyRanked #199 of 300 articles by views in matec web of conferences
Most read
Least read
Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 300 in total.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
This paper presents an experimental investigation of deep hole drilling using CNC milling machine. This experiment investigates the effect of machining parameters which are spindle speed, feed rate and depth of hole using minimum quantity lubricant on the roundness error. The experiment was designed using two level full factorial with four center point. Finally, the machining parameters were optimized in obtaining the minimum value of roundness error. The minimum value of roundness error for deep hole drilling is 0.0266 at the spindle speed is 800 rpm, feed rate is 60 mm/min, depth of hole is 70 mm and minimum quantity lubricant is 30ml/hr.
| Reference Key |
farhan2016optimizationmatec
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | Farhan, Kamaruzaman Anis;Azlan, Mohd Zain;Noordin, Mohd. Yusof;Farhad, Nadjarian; |
| Journal | matec web of conferences |
| Year | 2016 |
| DOI |
DOI not found
|
| URL | |
| Keywords | Keywords not found |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.