Plant Breeding and Drought in C3 Cereals: What Should We Breed For?

Clicks: 1
ID: 295794
2002
Free PDF
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This article has not been analysed, so there is no overall score — reader engagement is measured and shown alongside.
AI Quality Assessment
Not analyzed
Readership in this journal

Ranked #187 of 195 articles by views in Annals of botany

Most read Least read

Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 195 in total.

Mint this article as an NFT
Not yet minted

Create a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.

5 SUSD one-off · no wallet required
Sign in to mint
Abstract
Drought is the main abiotic constraint on cereal yield. Analysing physiological determinants of yield responses to water may help in breeding for higher yield and stability under drought conditions. The traits to select (either for stress escape, avoidance or tolerance) and the framework where breeding for drought stress is addressed will depend on the level and timing of stress in the targeted area. If the stress is severe, breeding under stress‐free conditions may be unsuccessful and traits that confer survival may become a priority. However, selecting for yield itself under stress‐alleviated conditions appears to produce superior cultivars, not only for optimum environments, but also for those characterized by frequent mild and moderate stress conditions. This implies that broad avoidance/tolerance to mild–moderate stresses is given by constitutive traits also expressed under stress‐free conditions. In this paper, we focus on physiological traits that contribute to improved productivity under mild–moderate drought. Increased crop performance may be achieved through improvements in water use, water‐use efficiency and harvest index. The first factor is relevant when soil water remains available at maturity or when deep‐rooted genotypes access water in the soil profile that is not normally available; the two latter conditions become more important when all available water is exhausted by the end of the crop cycle. Independent of the mechanism operating, a canopy able to use more water than another would have more open stomata and therefore higher canopy temperature depression, and 13C discrimination (Δ13C) in plant matter. The same traits would also seem to be relevant when breeding for hot, irrigated environments. Where additional water is not available to the crop, higher water‐use efficiency (WUE) appears to be an alternative strategy to improve crop performance. In this context Δ13C constitutes a simple but reliable measure of WUE. However, in contrast to lines performing better because of increased access to water, lines producing greater biomass due to superior WUE will have lower Δ13C values. WUE may be modified not only through a decrease in stomatal conductance, but also through an increase in photosynthetic capacity. Harvest index is strongly reduced by terminal drought (i.e. drought during grain filling). Thus, phenological traits increasing the relative amount of water used during grain filling, or adjusting the crop cycle to the seasonal pattern of rainfall may be useful. Augmenting the contribution of carbohydrate reserves accumulated during vegetative growth to grain filling may also be worthwhile in harsh environments. Alternatively, extending the duration of stem elongation without changing the timing of anthesis would increase the number of grains per spike and the harvest index without changing the amount of water utilized by the crop.
Reference Key
openalex_W2144167994 Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors J. L. Araus
Journal Annals of botany
Year 2002
DOI
10.1093/aob/mcf049
URL
https://academic.oup.com/aob/article-pdf/89/7/925/352998/mcf049.pdf
Keywords Keywords not found

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

Comments

No comments yet. Be the first to comment on this article.