On the fate of gas accreting at a low rate on to a black hole

Clicks: 1
ID: 295417
1999
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This article has not been analysed, so there is no overall score — reader engagement is measured and shown alongside.
AI Quality Assessment
Not analyzed
Readership in this journal

Ranked #630 of 908 articles by views in monthly notices of the royal astronomical society

Most read Least read

Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 908 in total.

Mint this article as an NFT
Not yet minted

Create a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.

5 SUSD one-off · no wallet required
Abstract
Gas supplied conservatively to a black hole at rates well below the Eddington rate may not be able to radiate effectively and the net energy flux, including the energy transported by the viscous torque, is likely to be close to zero at all radii. This has the consequence that the gas accretes with positive energy so that it may escape. Accordingly, we propose that only a small fraction of the gas supplied actually falls on to the black hole, and that the binding energy it releases is transported radially outward by the torque so as to drive away the remainder in the form of a wind. This is a generalization of and an alternative to an 'ADAF' solution. Some observational implications and possible ways to distinguish these two types of flow are briefly discussed.
Reference Key
openalex_W2050444942 Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors R. D. Blandford, Mitchell C. Begelman
Journal monthly notices of the royal astronomical society
Year 1999
DOI
10.1046/j.1365-8711.1999.02358.x
URL
Keywords Keywords not found

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

No comments yet. Be the first to comment on this article.