numerical simulation of the heat treatment of the weld for steam generator
Clicks: 203
ID: 254261
2016
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Emerging Content
30.0
/100
203 views
24 readers
AI Quality Assessment
Not analyzed
Readership in this journal
EmergingRanked #55 of 98 articles by views in journal of the formosan medical association = taiwan yi zhi
Most read
Least read
Bar heights use a square-root scale.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
Heat treatment of the weld of the steam generator is investigated in this paper. Annealing is realized by system of heating elements that are placed on casing of the generator. An experiment using real parameters and a computational fluid dynamics analysis using COMSOL Multiphysics software were performed. Experimental data were compared with results of the analysis. Boundary conditions for numerical prediction had been derived on basis of results obtained from a supplementary calibration experiment. There was good correlation between predicted and measured data. Based on results it can be stated that 67 heating elements with heating output of 60-70 % of maximum range is sufficient number for required heat treatment.
| Reference Key |
machkov2016metalurgijanumerical
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;A. Macháčková;P. Kuchta;Z. Klečková;R. Kocich;J. Szwed |
| Journal | journal of the formosan medical association = taiwan yi zhi |
| Year | 2016 |
| DOI |
DOI not found
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.