crystallization and structure of cast a390.0 alloy with melt overheating temperature

Clicks: 275
ID: 254088
2012
Free PDF
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This article has not been analysed, so there is no overall score — reader engagement is measured and shown alongside.
AI Quality Assessment
Not analyzed
Readership in this journal
Steady

Ranked #39 of 98 articles by views in journal of the formosan medical association = taiwan yi zhi

Most read Least read

Bar heights use a square-root scale.

Mint this article as an NFT
Not yet minted

Create a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.

5 SUSD one-off · no wallet required
Abstract
The paper presents the research on the influence of melt overheating temperature on crystallization parameters and primary structure of cast AlSi17Cu5Mg (A390.0) alloy overheated to temperature: 820 °C, 880 °C, 940 °C and 1 000 °C. It was found that the degree of overheating influences the change of microstructure significantly and morphologies of primary silicon of the castings from Al-Si alloys. Research has shown that the overheating of the liquid metal bath is one of the methods of finding more applications of hypereutectic Al-Si system alloys without the addition of modifiers.
Reference Key
pitkowski2012metalurgijacrystallization Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors
Journal journal of the formosan medical association = taiwan yi zhi
Year 2012
DOI
DOI not found
URL
Keywords

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

No comments yet. Be the first to comment on this article.