research into plastic deformation of double reduced sheets
Clicks: 160
ID: 231864
2018
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Emerging Content
30.0
/100
160 views
18 readers
AI Quality Assessment
Not analyzed
Readership in this journal
EmergingRanked #116 of 136 articles by views in seminars in cancer biology
Most read
Least read
Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 136 in total.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
This contribution focuses on examining properties of thin steel sheets, which have been used to produce packages. Thin steel sheets for producing packages have been created with a different method (considering their thickness) than other thin steel sheets, such as sheets for the automobile industry. Steel sheets thinner than circa 0.18 mm are produced with a simple rolling and followed by annealing. Annealing can be completed through a batch process or a continuous process. Steel sheets with a thickness less than 0.13 mm are produced using a second reduction. Taking into account the considerably different strength and plastic properties of the sheets produced with simple rolling and the sheets produced with a second reduction, two types of materials are evaluated and analyzed in this contribution. Examined materials have been produced with different methods: The first material was continuously annealed after being rolled; the second was deformed using a second reduction without any subsequent annealing. Both used materials possess different final properties. The research focused on evaluation of the strength and plastic properties of the packaging sheets during various stress-strain states (uniaxial tensile test and biaxial tensile test—bulge test). The analysis also focused on the factors that led to a lack of inhomogeneity in the plastic deformation, mainly during the uniaxial tensile test causing the localization of the plastic deformation.
| Reference Key |
spik2018metalsresearch
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;Emil Spišák;Janka Majerníková;Emília Duľová Spišáková;Ľuboš Kaščák |
| Journal | seminars in cancer biology |
| Year | 2018 |
| DOI |
10.3390/met8020099
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.