toughening of bisphenol-a diglycidyl ether-based epoxy by modification with hydroxyl-terminated liquid natural rubber
Clicks: 293
ID: 227153
2017
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Steady Performance
30.0
/100
293 views
38 readers
AI Quality Assessment
Not analyzed
Readership in this journal
SteadyRanked #7 of 43 articles by views in atmospheric environment
Most read
Least read
Bar heights use a square-root scale.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
Hydroxyl-terminated liquid natural rubbers (HTNRs), prepared by the Photo-Fenton reaction, were used to modify bisphenol-A diglycidyl ether-based epoxy (DGEBA). A chemical link between HTNRs and the epoxy resin was promoted employing toluene diisocyanate. The reactions between elastomers and epoxy resin were followed by FTIR. The mechanical properties of the composites were evaluated and the microstructure was investigated using scanning electronic microscopy. The results showed that the impact resistance of HTNR-modified DGEBA was superior to that of the pure epoxy resin. For the composites with HTNR, the impact resistance increased with elastomer concentration up to 2.5 parts per hundred parts of resin. Higher concentration of HTNR resulted in larger particles which gave lower impact values.
| Reference Key |
pham2017aseantoughening
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;H. L. Pham;B. T. Do;T. S. Pham;D. G. Le |
| Journal | atmospheric environment |
| Year | 2017 |
| DOI |
10.29037/ajstd.346
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.