electrochemical determination of trace mercury in water sample using edta-cpe modified electrode

Clicks: 197
ID: 224206
2018
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This article has not been analysed, so there is no overall score — reader engagement is measured and shown alongside.
AI Quality Assessment
Not analyzed
Readership in this journal
Steady

Ranked #27 of 46 articles by views in crystals

Most read Least read

Bar heights use a square-root scale.

Mint this article as an NFT
Not yet minted

Create a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.

5 SUSD one-off · no wallet required
Abstract
The analytical performance of the EDTA-CPE sensor that is designed for the detection of metals was studied. EDTA plays an important role in the complexation of metal ions because of their good and high response to these ions. The modified electrode EDTA-CPE was used for the voltammetric determination of mercury ions (square wave voltammetry). Sodium chloride solution 0.3mol−1 was used as the support electrolyte. Using optimal parameters, calibration graph is linear (varying from 5 to 35∗10−4mol/l) for 5min of pre-concentration time with the detection limit of 16, 6×10−9molL−1. These results indicate that the developed method is simple, with high stability and sensitivity for the determination of low concentration of Hg (II). Keywords: Mercury, Voltammetric determination, Modified electrode, Square wave voltammetry
Reference Key
moutcine2018sensingelectrochemical Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors ;A. Moutcine;A. Chtaini
Journal crystals
Year 2018
DOI
DOI not found
URL
Keywords

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

No comments yet. Be the first to comment on this article.