prototype implementation and experimental analysis of water heating using recovered waste heat of chimneys
Clicks: 312
ID: 208121
2015
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Steady Performance
30.0
/100
312 views
59 readers
AI Quality Assessment
Not analyzed
Readership in this journal
SteadyRanked #3 of 16 articles by views in gateways : international journal of community research & engagement
Most read
Least read
Bar heights use a square-root scale.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
This work discusses a waste heat recovery system (WHRS) applied to chimneys for heating water in residential buildings. A prototype illustrating the suggested system is implemented and tested. Different waste heat scenarios by varying the quantity of burned firewood (heat input) are experimented. The temperature at different parts of the WHRS and the gas flow rates of the exhaust pipes are measured. Measurements showed that the temperature of 95 L tank of water can be increased by 68 °C within one hour. Obtained results show that the convection and radiation exchanges at the bottom surface of the tank have a considerable impact on the total heat transfer rate of the water (as high as 70%).
| Reference Key |
khaled2015caseprototype
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;Mahmoud Khaled;Mohamad Ramadan;Khaled Chahine;Ali Assi |
| Journal | gateways : international journal of community research & engagement |
| Year | 2015 |
| DOI |
10.1016/j.csite.2015.03.004
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.