An Experimental Investigation on Transpiration Cooling Part II: Comparison of Cooling Methods and Media
Clicks: 214
ID: 20604
2004
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Popular Article
59.6
/100
214 views
169 readers
Trending
AI Quality Assessment
Not analyzed
Readership in this journal
PopularRanked #30 of 48 articles by views in international journal of rotating machinery
Most read
Least read
Bar heights use a square-root scale.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
This article attempts to provide a cooling performance comparison of various mass transfer cooling methods and different cooling media through two experiments. In the first experiment, pressurized air was used as a cooling medium
and two different circular tubes were used as specimens. One is made of impermeable solid material with four rows of discrete holes to simulate film cooling, and the other consists
of sintered porous material to create a porous transpiration cooling effect. The natures of transpiration cooling and film cooling including leading and trailing edge injection cooling
were compared. This experiment found that by using a gaseous cooling medium, transpiration cooling could provide a higher cooling effect and a larger coolant coverage
than film cooling in the leading stagnation region, and on the side of the specimen at the same coolant injection flow rates; but in the trailing stagnation region, the traditional coolant
injection method through discrete film holes might be better than transpiration cooling, especially for turbine blades with thin trailing edges. In the second experiment, the cooling effects of gaseous and liquid media on the same porous tube's surface were compared. This experiment showed that the porous areas cooled using gaseous and liquid cooling media were almost identical, but the cooling effect of liquid evaporation
was much higher than that of gaseous cooling, especially in the leading and trailing stagnation regions of turbine blades. This important discovery makes it possible to solve
the stagnation region problems in turbine blade cooling.
| Reference Key |
wang2004aninternational
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | Wang, J. H.;Messner, J. ;Stetter, H. ; |
| Journal | international journal of rotating machinery |
| Year | 2004 |
| DOI |
DOI not found
|
| URL | |
| Keywords | Keywords not found |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.