separation and speciation analysis of zinc from flammulina velutipes

Clicks: 317
ID: 204810
2015
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This article has not been analysed, so there is no overall score — reader engagement is measured and shown alongside.
AI Quality Assessment
Not analyzed
Readership in this journal
Popular

Ranked #12 of 51 articles by views in polymers from renewable resources

Most read Least read

Bar heights use a square-root scale.

Mint this article as an NFT
Not yet minted

Create a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.

5 SUSD one-off · no wallet required
Abstract
Orthogonal experiment was applied to optimize the water extraction parameters of zinc from Flammulina velutipes, and then the extracts were separated by membrane filter (0.45 μm) and D101 macroporous resin. Six different species of Zn were obtained and the Zn content of various species were determined by flame atomic absorption spectrometry. The optimized conditions for the extraction of Zn were: ratio of dried material to water, 1:30; extraction temperature, 75°C; extraction time, 120 minutes. About 34.43 μg Zn was extracted from 1 g dried F. velutipes powder under the optimal conditions. The recovery value for Zn was 96.5% with a low relative standard deviation. In addition, the content of the organic state of Zn was more than that of the inorganic state, and most of the organic state Zn was found in the polysaccharide and protein fractions.
Reference Key
liu2015journalseparation Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors ;Fang Liu;Fei Pei;Alfred Mugambi Mariga;Le Gao;Guitang Chen;Liyan Zhao
Journal polymers from renewable resources
Year 2015
DOI
10.1016/j.jfda.2014.06.008
URL
Keywords

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

No comments yet. Be the first to comment on this article.