numerical study of finned type heat exchangers for ices exhaust waste heat recovery
Clicks: 165
ID: 198409
2014
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Popular Article
30.0
/100
165 views
30 readers
AI Quality Assessment
Not analyzed
Readership in this journal
PopularRanked #12 of 16 articles by views in gateways : international journal of community research & engagement
Most read
Least read
Bar heights use a square-root scale.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
In this paper, two cases of heat exchangers (HEXs) which previously were used in exhaust of internal combustion engines (ICEs) are modeled numerically to recover the exhaust waste heat. It is tried to find the best viscous model to obtain the results with more accordance by experimental results. One of the HEXs is used in a compression ignition (CI) engine with water as cold fluid and other is used in a spark ignition (SI) engine with a mixture of 50% water and 50% ethylene glycol as cold fluid. As a main outcome, SST k–ω and RNG k–ε are suitable viscous models for these kinds of problems. Also, effect sizes and numbers of fins on recovered heat amount are investigated in various engine loads and speeds.
| Reference Key |
hatami2014casenumerical
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;M. Hatami;D.D. Ganji;M. Gorji-Bandpy |
| Journal | gateways : international journal of community research & engagement |
| Year | 2014 |
| DOI |
10.1016/j.csite.2014.07.002
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.