the effect of shoulder on the strength of the oval tenon-mortise joint

Clicks: 180
ID: 197451
2016
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This article has not been analysed, so there is no overall score — reader engagement is measured and shown alongside.
AI Quality Assessment
Not analyzed
Readership in this journal
Steady

Ranked #23 of 30 articles by views in Journal of water and health

Most read Least read

Bar heights use a square-root scale.

Mint this article as an NFT
Not yet minted

Create a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.

5 SUSD one-off · no wallet required
Abstract
This paper presents the results of a parallel examination on the strength of oval tenon-mortise joints in two groups of test joints. Joints from group A were made with both shoulders of tenon, while joints from group B were made without the lower shoulder. Examination of strength was conducted on a chair joints rear leg-rail. The results of the examination indicated that joints in group A (oval tenon with the upper and lower shoulder) had a higher average bending moment capacity in comparison with the joints in group B (oval tenon without the lower shoulder). However, the significance of difference in strength between the two groups of joints was not confirmed by the statistical analysis.
Reference Key
igor2016glasnikthe Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors ;Džinčić Igor;Nestorović Biserka;Dacić Vojislav
Journal Journal of water and health
Year 2016
DOI
10.2298/GSF151109001D
URL
Keywords

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

No comments yet. Be the first to comment on this article.