optimization of parameters in the synthesis of 0.90pb(zn1/3nb2/3)o3–0.10pbtio3 (pzn-10pt) powders obtained by the mixed oxides method
Clicks: 370
ID: 197237
2017
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Emerging Content
30.0
/100
370 views
59 readers
AI Quality Assessment
Not analyzed
Readership in this journal
EmergingRanked #11 of 111 articles by views in medicinal chemistry (shariqah (united arab emirates))
Most read
Least read
Bar heights use a square-root scale.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
Preventing the formation of the pyrochlore phase in the synthesis of PZN-PT powders requires controlling calcination parameters such as temperature, soaking time and atmosphere. These parameters were examined extensively to determine the time and temperature at which the perovskite phase is the majority phase, as well as the atmosphere that facilitates the formation of this phase. A maximum of 74% of perovskite phase was obtained under the following conditions: 1000 °C, 4 h in nitrogen atmosphere. In this work, we studied the influence of these parameters, which were optimized, on the formation the perovskite phase in PZN-10PT powders synthesized by the conventional solid state method.
| Reference Key |
raigoza2017boletnoptimization
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;C.F.V. Raigoza;D. Garcia;J.A. Eiras;R.H.G.A. Kiminami |
| Journal | medicinal chemistry (shariqah (united arab emirates)) |
| Year | 2017 |
| DOI |
10.1016/j.bsecv.2016.03.002
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.