processes at the inetrface molten metal-sand mold
Clicks: 3
ID: 190429
2014
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Steady Performance
0.6
/100
3 views
2 readers
AI Quality Assessment
Not analyzed
Readership in this journal
SteadyRanked #98 of 98 articles by views in journal of the formosan medical association = taiwan yi zhi
Most read
Least read
Bar heights use a square-root scale.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
The processes that take place at the liquid metal-sand mold interface during the casting and crystallization of metal were studied in this paper. The mold was made using the CO2 – method, with the addition of active components, such as: MgO, TiO2, AlK(SO4)2 and Na2SO4. At the liquid steel pouring temperature, these active components undergo decomposition in the mold, caused by heat release during pouring, crystallization and cooling of castings. Silicates, which have an important influence on casting surface quality, are formed as a result of the interaction between the mould material and liquid steel.
| Reference Key |
janjuevi2014metalurgijaprocesses
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;Z. Janjušević;Z. Gulišija;M. Mihailović;A. Patarić |
| Journal | journal of the formosan medical association = taiwan yi zhi |
| Year | 2014 |
| DOI |
DOI not found
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.