wear behaviour of a356/tial3 in situ composites produced by mechanical alloying
Clicks: 204
ID: 179412
2016
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Steady Performance
30.0
/100
204 views
26 readers
AI Quality Assessment
Not analyzed
Readership in this journal
SteadyRanked #89 of 136 articles by views in seminars in cancer biology
Most read
Least read
Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 136 in total.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
In this study, the effects of in situ TiAl3 particles on dry sliding wear behavior of A356 aluminum alloy (added Ti) composites were investigated. The wear samples were prepared by adding different amounts of Ti (4%, 6%, and 8%) into A356 powder alloy by mechanical alloying. The mechanically alloyed powders were cold pressed at 600 MPa and sintered 530 °C for 1 h in argon atmosphere and cooled in the furnace. After the sintering process, the samples were characterized. The results show that AlTi and TiAl3 intermetallic phases were formed and their amount increased depending on the amount of Ti added into A356 powder alloy. Out of the samples sintered with different titanium amounts (1 h at 530 °C), the highest hardness value and, accordingly, the lowest wear amount, were observed in the alloy containing 8% Ti.
| Reference Key |
am2016metalswear
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;Seda Çam;Vedat Demir;Dursun Özyürek |
| Journal | seminars in cancer biology |
| Year | 2016 |
| DOI |
10.3390/met6020034
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.