pengaruh penambahan karet silikon terhadap sudut kontak hidropobik dan karakteristik arus bocor permukaan pada bahan resin epoksi
Clicks: 18
ID: 177470
2010
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Steady Performance
5.1
/100
18 views
8 readers
AI Quality Assessment
Not analyzed
Readership in this journal
SteadyRanked #31 of 41 articles by views in Nature chemistry
Most read
Least read
Bar heights use a square-root scale.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
Currently, polymer materials such as epoxy resin have been used as an insulator in the distribution and
transmission line. Some advantages of using this epoxy resin material having the dielectric properties are better than
porcelain and glass insulators. On the other side, epoxy resins are also disadvantage the surface is hygroscopic. For
the repair was done by adding the surface properties of silicone rubber material
This paper describes the effect of adding silicone rubber against contact angle of hidrophobicity and surface
leakage current characteristics of epoxy resin materials ( Di-Glycidyl Ether of Bisphenol A (DGEBA) and
Methaphenylene-Diamine (MPDA). The study was conducted in the laboratory using the electrode method IEC
587:1984 with NH4Cl contaminants. The voltage applied to the epoxy resin sample at 3.5 kV and 50 Hz frequency
The experimental results showed that the addition of silicon rubber in epoxy resin makes the surface material
contact angle increases. The higher percentage of silicone rubber, the greater the contact angle and the longer time
required for the occurrence of surface discharge.
transmission line. Some advantages of using this epoxy resin material having the dielectric properties are better than
porcelain and glass insulators. On the other side, epoxy resins are also disadvantage the surface is hygroscopic. For
the repair was done by adding the surface properties of silicone rubber material
This paper describes the effect of adding silicone rubber against contact angle of hidrophobicity and surface
leakage current characteristics of epoxy resin materials ( Di-Glycidyl Ether of Bisphenol A (DGEBA) and
Methaphenylene-Diamine (MPDA). The study was conducted in the laboratory using the electrode method IEC
587:1984 with NH4Cl contaminants. The voltage applied to the epoxy resin sample at 3.5 kV and 50 Hz frequency
The experimental results showed that the addition of silicon rubber in epoxy resin makes the surface material
contact angle increases. The higher percentage of silicone rubber, the greater the contact angle and the longer time
required for the occurrence of surface discharge.
| Reference Key |
syakur2010majalahpengaruh
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;Abdul Syakur;Ika Novia;Sarjiya Sarjiya;Tumiran Tumiran;Hamzah Berahim |
| Journal | Nature chemistry |
| Year | 2010 |
| DOI |
DOI not found
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.