effect of blade outlet angle on unsteady hydrodynamic force of closed-type centrifugal pump with single blade
Clicks: 137
ID: 174751
2014
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Popular Article
30.0
/100
137 views
29 readers
AI Quality Assessment
Not analyzed
Readership in this journal
PopularRanked #427 of 475 articles by views in ACS omega
Most read
Least read
Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 475 in total.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
Geometrically, the single-blade centrifugal impeller, commonly used today as a sewage pump, is not axially symmetric. For this reason, the static pressure around the impeller fluctuates greatly when the impeller is rotating, and not only the radial thrust but also the axial thrust shows large fluctuations. Therefore, it is extremely important for the improvement of pump reliability to quantitatively grasp these fluctuating hydrodynamic forces. In this study, we investigated the unsteady hydrodynamic forces in a closed-type centrifugal pump with a single blade for different blade outlet angles using a numerical analysis that takes into account both experiment and the leakage flow. The results clearly showed the effect of the blade outlet angle on that act on the impeller. The root-mean-square value of the fluctuating component of the total radial thrust was roughly the same for whichever impeller at low flow rate, but at high flow rates, the value increased for impellers with larger blade outlet angles. Moreover, when the leakage flow rate increased with increasing static pressure around the impeller, such that the rear and front shroud parts were subject to high pressure, the absolute value of the axial thrust on both these parts increased.
| Reference Key |
nishi2014internationaleffect
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;Yasuyuki Nishi;Junichiro Fukutomi |
| Journal | ACS omega |
| Year | 2014 |
| DOI |
10.1155/2014/838627
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.