support tool for anchoring system optimization of titanium craniofacial prostheses
Clicks: 149
ID: 166098
2016
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Steady Performance
30.0
/100
149 views
7 readers
AI Quality Assessment
Not analyzed
Readership in this journal
SteadyRanked #201 of 435 articles by views in acta botânica brasílica
Most read
Least read
Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 435 in total.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
Titanium prostheses are artificial components used during cranioplasty, which can be made with the Incremental Sheet Forming (ISF). To repair the craniofacial defects, the implant must be fixed to the skull, so an adequate anchoring system is necessary. Because there are no specific guidelines regarding this system, the aim of this study was to present a methodology for the identification of the optimal screw shank diameter and the overlap length, considering different damage areas and accidental external loads. In this method, a numerical model for structural analysis, a statistical approach and a metamodeling technique were coupled. The results demonstrate that this methodology can be used as a decision support tool in the titanium prostheses design, ensuring the best anchorage.
| Reference Key |
claudio2016matecsupport
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;Ciancio Claudio;Caruso Maria Vittoria;Fragomeni Gionata;Ambrogio Giuseppina |
| Journal | acta botânica brasílica |
| Year | 2016 |
| DOI |
10.1051/matecconf/20168011004
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.