performance assurance of mechanical engineering construction in the existence of cracks
Clicks: 209
ID: 165238
2019
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Emerging Content
30.2
/100
209 views
48 readers
AI Quality Assessment
Not analyzed
Readership in this journal
EmergingRanked #83 of 435 articles by views in acta botânica brasílica
Most read
Least read
Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 435 in total.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
The purpose of this paper is to consider the development of engineering ways of preventing the further development of through cracks in the sheet elements of the complex technical structures. The latest individual approach to the assessment and assurance of performance of structures with cracks, which is to take into account the features of their operation, has been applied in this work. Preference is given to methods that reduce the concentration in the danger zone. Studies have shown that the most appropriate and effective ways to prevent the further development of a through crack are the structural methods and combinations of the structural and technological methods. The effectiveness of these methods was determined on the basis of the strength uniformity approach of structural elements with a crack. The criterion of strength uniformity from the position of fatigue and brittle strength with an error on the safe side is the value of theoretical stress concentration factor [K]. The[K] value was made on the basis of generalization and analysis of cases of crack formation, the results of tests of typical components of hull structures and welded joints. The safe concentration of stresses near the holes of various purposes in the members of the machine-building structures is in the range from 2 to 4. Taking into account the relevant requirements for the ratio of the radius of curvature and the width of the cutout, we obtain 3.5. The value of the criterion К1 is determined by the ratio of the calculated crack length to the diameter of the hole drilled at its ends and the location of the crack.
| Reference Key |
nikolay2019matecperformance
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;Velikanov Nikolay;Koryagin Sergey;Sharkov Oleg |
| Journal | acta botânica brasílica |
| Year | 2019 |
| DOI |
10.1051/matecconf/201928702004
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.