transparency effect of electrolyte on light back-scattering in dye-sensitized solar cells

Clicks: 251
ID: 159834
2015
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This article has not been analysed, so there is no overall score — reader engagement is measured and shown alongside.
AI Quality Assessment
Not analyzed
Readership in this journal
Steady

Ranked #11 of 30 articles by views in journal of non-crystalline solids

Most read Least read

Bar heights use a square-root scale.

Mint this article as an NFT
Not yet minted

Create a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.

5 SUSD one-off · no wallet required
Abstract
Conventionally, a film of TiO2 particles of ~300 nm size is employed in DSCs as the back reflector film to enhance the light harvesting. In this study, two electrolytes with different transparencies, iodide-based and cobalt-based electrolytes, were used to investigate the transparency effect of electrolytes on light back-scattering from back scattering layer and also to study its effect on the performance of DSCs. The use of cobalt-based electrolyte is recommended from the view point of optical properties as due to the light absorption in electrolytes, the current density losses are 2.9mA/cm2 and 4.2 mA/cm2 in cobalt- and iodide-based electrolytes, respectively, and the transmission of 100% is observed for cobalt-based electrolyte in 500-600 nm in spite of iodide-based electrolyte. Use of light back-scattering layer, unlike iodide-based cell, causes external quantum efficiency in cobalt-base cell to increase for the wavelengths lower than 350 nm since cobalt-base electrolyte has transparency in this region. In addition, optical calculations demonstrate that in the range 400-500 nm, in which dye has a noticeable absorption, absorption loss is 40% and 30% for iodide- and cobalt-based electrolytes, respectively.
Reference Key
sharifi2015journaltransparency Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors ;N. Sharifi
Journal journal of non-crystalline solids
Year 2015
DOI
DOI not found
URL
Keywords

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

No comments yet. Be the first to comment on this article.