production of high strength hollow shafts using tool hardening and q-p process

Clicks: 155
ID: 155771
2015
Free PDF
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This article has not been analysed, so there is no overall score — reader engagement is measured and shown alongside.
AI Quality Assessment
Not analyzed
Readership in this journal
Popular

Ranked #243 of 435 articles by views in acta botânica brasílica

Most read Least read

Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 435 in total.

Mint this article as an NFT
Not yet minted

Create a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.

5 SUSD one-off · no wallet required
Sign in to mint
Abstract
Innovation opens new opportunities in the field of processing hollow semi-products, as it offers the potential for manufacturing complex-shaped structural parts with enhanced properties. This introduces a manufacturing route comprising the following steps: internal high pressure forming, hot stamping and thermomechanical Q&P processing. In this manufacturing route, the demonstration product, a tube–shaped stock, is first austenitized. It is then expanded in a closed die by internal pressure of nitrogen until the material touches the die wall. As a result, it cools down quickly and martensite begins to form. At a temperature above the Mf, the cooling is interrupted and the workpiece is transferred to a furnace and tempered. The furnace temperature is below the Ms temperature. Within several minutes, a mixed microstructure forms, consisting of martensite and stabilized retained austenite. Thanks to this microstructure, the material exhibits a favourable combination of high strength and adequate ductility. Martensite imparts sufficient strength to the material whereas the retained austenite provides ductility. At a carbon level of approximately 0.4 % and with a simple Si-Mn-Cr-based chemistry, strengths of 2000 MPa and A5 mm elongations of 15% can be achieved.
Reference Key
bohuslav2015matecproduction Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors Masek Bohuslav, Vorel Ivan, Opatová Kateřina, Kurka Petr, Hahn Frank, Mahn Uwe
Are you one of these authors? Claim your profile
Journal acta botânica brasílica
Year 2015
DOI
10.1051/matecconf/20152106009
URL
http://dx.doi.org/10.1051/matecconf/20152106009
Keywords
engineering (general) civil engineering (general)

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

Comments

No comments yet. Be the first to comment on this article.