tensile strength of 3d textiles reinforced cementitious composites plates

Clicks: 195
ID: 150320
2018
Free PDF
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This article has not been analysed, so there is no overall score — reader engagement is measured and shown alongside.
AI Quality Assessment
Not analyzed
Readership in this journal
Steady

Ranked #84 of 435 articles by views in acta botânica brasílica

Most read Least read

Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 435 in total.

Mint this article as an NFT
Not yet minted

Create a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.

5 SUSD one-off · no wallet required
Sign in to mint
Abstract
Tensile plate specimens with dimension of 450×100×40mm were cast with 3D glass fabric having three different thicknesses 6, 10 and 15mm to measure their tensile strength. Plates with one and two layers of chicken wires, as well as micro steel fiber of 0.75% volume fraction were tested under tensile for comparison with references plates. Cement mortar with 61.2MPa cube compressive strength at 28 days was designed for casing the plates. The results indicated that after cracking of the mortar the textile reinforcement adds a strain hardening trajectory, that cause failure to occurs at slightly higher load and a higher strain. The improvement in tensile strength at 28 days ranged between 5 to 30%, and for 90 days between 5 to 60% for the three types of fibres used. Based on the results a significant increase was indicated with micro steel fiber.
Reference Key
ikbal2018matectensile Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors ;Gorgis Ikbal;Abbas Waleed;Moneen Nadia
Journal acta botânica brasílica
Year 2018
DOI
10.1051/matecconf/201816204008
URL
https://doi.org/10.1051/matecconf/201816204008
Keywords
engineering (general) civil engineering (general)

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

Comments

No comments yet. Be the first to comment on this article.