development of a three-dimensional hygrothermal model of a historic building in wufi®plus vs energyplus
Clicks: 32
ID: 150195
2019
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Emerging Content
10.0
/100
32 views
15 readers
AI Quality Assessment
Not analyzed
Readership in this journal
EmergingRanked #378 of 435 articles by views in acta botânica brasílica
Most read
Least read
Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 435 in total.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
Historic artefacts are crucial to transmit history to future generations. Depending on the characteristics of their components these objects can be prone to biological attacks, chemical decay or even mechanical degradation. These three types of decay are induced by the indoor relative humidity and temperature, which are largely dependent on the characteristics of the building envelope, the outdoor climate and the number of occupants. In order to attain a proper indoor climate for the conservation of the artefacts it may be necessary to implement some types of changes. However, and due to the high heritage value of most of the buildings that house these artefacts, any type of changes has to be thoroughly studied prior to its implementation. These studies are usually carried out using a hygrothermal model of the building validated by the measured indoor conditions. The development of these models is entirely based on non-destructive procedures, which is a key factor when studying historic buildings. The yearly indoor climate of a 13th century church in Lisbon was measured and then used to develop a hygrothermal model of the church in two of the most used software in cultural heritage: EnergyPlus and WUFI®Plus. The obtained results for each model were compared against the measured indoor temperature and water vapour pressure to determine which are the advantages of the two software.
| Reference Key |
a.2019matecdevelopment
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;Coelho Guilherme B. A.;Entradas Silva Hugo;Henriques Fernando M. A. |
| Journal | acta botânica brasílica |
| Year | 2019 |
| DOI |
10.1051/matecconf/201928202079
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.