study on micro extra deep drawing process with ultrahigh fluid pressure and press motion controls
Clicks: 122
ID: 148400
2015
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Popular Article
30.0
/100
122 views
19 readers
AI Quality Assessment
Not analyzed
Readership in this journal
PopularRanked #288 of 435 articles by views in acta botânica brasílica
Most read
Least read
Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 435 in total.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
A novel micro extra deep drawing process with ultrahigh fluid pressure and press motion controls are developed. A space between the blank and 1st punch is made by the press motion at the 2nd drawing stage and the ultrahigh pressure is applied so as to be disappeared this space. It can enhance a material flow into the die cavity because the ultrahigh pressure acts on the blank at side wall. In addition, a friction holding effect occurs, which prevents the thickness reduction at punch shoulder and side wall. Due to these mechanisms, the micro cup with aspect ratio of 2.0 can be successfully fabricated by micro extra deep drawing in FE simulation, although it cannot be fabricated by conventional micro deep drawing and micro hydromechanical deep drawing.
| Reference Key |
hideki2015matecstudy
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;Sato Hideki;Kondo Daiki;Manabe Ken-ichi;Ito Kuniyoshi |
| Journal | acta botânica brasílica |
| Year | 2015 |
| DOI |
10.1051/matecconf/20152109016
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.