using simplified models to assist fault detection and diagnosis in large hydrogenerators

Clicks: 132
ID: 141238
2017
Free PDF
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This article has not been analysed, so there is no overall score — reader engagement is measured and shown alongside.
AI Quality Assessment
Not analyzed
Readership in this journal
Popular

Ranked #432 of 475 articles by views in ACS omega

Most read Least read

Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 475 in total.

Mint this article as an NFT
Not yet minted

Create a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.

5 SUSD one-off · no wallet required
Sign in to mint
Abstract
Based on experimental evidence collected in a set of twenty 700 MW hydrogenerators, this article shows that the operating conditions of large hydrogenerators journal bearings may have unpredictable and significant changes, without apparent reasons. These changes prevent the accurate determination of bearing dynamic coefficients and make the prediction of these machines dynamic behavior unfeasible, even using refined models. This makes it difficult to differentiate the normal changes in hydrogenerators dynamics from the changes created by a fault event. To overcome such difficulty, this article proposes a back-to-basics step, the using of simplified mathematical models to assist hydrogenerators vibration monitoring and exemplifies this proposal by modeling a 700 MW hydrogenerator. A first model estimates the influence of changes in bearing operating conditions in the bearing stiffnesses, considering only the hydrodynamic effects of an isoviscous oil film with linear thickness distribution. A second model simulates hydrogenerators dynamics using only 10 degrees of freedom, giving the monitored vibrations as outputs, under normal operating conditions or in the presence of a fault. This article shows that simplified models may give satisfactory results when bearing operating conditions are properly determined, results comparable to those obtained by more refined models or by measurements in the modeled hydrogenerator.
Reference Key
junior2017internationalusing Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors ;Geraldo Carvalho Brito Junior;Roberto Dalledone Machado;Anselmo Chaves Neto
Journal ACS omega
Year 2017
DOI
10.1155/2017/9258456
URL
http://dx.doi.org/10.1155/2017/9258456
Keywords
engineering (general) civil engineering (general)

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

Comments

No comments yet. Be the first to comment on this article.