a study of microstructure and tensile property with casting s45c welding
Clicks: 224
ID: 134029
2018
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Steady Performance
30.0
/100
224 views
38 readers
AI Quality Assessment
Not analyzed
Readership in this journal
SteadyRanked #55 of 435 articles by views in acta botânica brasílica
Most read
Least read
Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 435 in total.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
For energy saving and longer life time of a large casting iron may use of weld repairs or make up to more save manufacture time and energy than re-casting. Such as breakage, crack and wear in large casting iron castings used weld to repair casting for eco-energy.
The purpose of this study is to investigate the dissimilar joint property of S45C carbon steel with the multi-layer method and the multi-pass welding method. Four weld rods, experimentally examined the influence on microstructures, which were marked as A, B, C and D, respectively. The microstructures of joint bead were observed by the optical microscope. The specimens of tensile test were made according to ASTM E8M. The experimental results were shown as following:
1. The pearlite structures and the bainite structures were formed in welded zone by the weld rod of middle carbon steels. The yield strength and ultimate strength of the specimens were 360MPa and 460MPa.
2. The feature of welded specimen was close to stainless steel due to the stainless steel rod included some Cr and Ni. In addition, a ferritic-austenitic two-phase stainless steel was observed in optical microscope.
| Reference Key |
chin-guo2018mateca
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;Kuo Chin-Guo;Hwang Lih-Ren;Kang Yen-Tien |
| Journal | acta botânica brasílica |
| Year | 2018 |
| DOI |
10.1051/matecconf/201818500032
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.