Measurement of residual stresses in Al 2 O 3 /Ni laminated composites using an X-ray diffraction technique

Clicks: 392
ID: 118203
2004
Free PDF
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This article has not been analysed, so there is no overall score — reader engagement is measured and shown alongside.
AI Quality Assessment
Not analyzed
Readership in this journal
Popular

Ranked #4 of 44 articles by views in journal of materials science

Most read Least read

Bar heights use a square-root scale.

Mint this article as an NFT
Not yet minted

Create a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.

5 SUSD one-off · no wallet required
Sign in to mint
Abstract
Using an X-ray diffraction technique, macro-residual stresses were measured in laminated composites consisting of alternating layers of α-Al2O3 and nickel. The in-plane thermal mismatch stresses which develop during fabrication were found to be compressive and tensile in the α-Al2O3 and nickel layers, respectively. The magnitude of the in-plane stresses was found to be ≈ 110 MPa. Models of laminate structures predict the stress state to be biaxial in the plane of the layers. However, substantial stresses were observed perpendicular to the plane of the laminate; this stress might be due to the hot-pressing procedure used to fabricate the samples. The stress on the side surface of a laminate was measured using the indentation method and the results were consistent with those obtained by the X-ray method. Three samples were heated to 700, 900 and 1000 °C, respectively, and then cooled to test the effect of stress relaxation of the residual stresses due to the thermal expansion. The heat treatments (700–1000 °C) had no effect on the measured stress states of the laminates.
Reference Key
hehn2004journalmeasurement Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors L. Hehn;C. Zheng;J. J. Mecholsky;C. R. Hubbard;L. Hehn;C. Zheng;J. J. Mecholsky;C. R. Hubbard;
Journal journal of materials science
Year 2004
DOI
doi:10.1007/BF00356131
URL
https://doi.org/10.1007/bf00356131
Keywords
materials science polymer sciences solid mechanics general classical mechanics characterization and evaluation of materials crystallography and scattering methods

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

Comments

No comments yet. Be the first to comment on this article.