Numerical and experimental studies of water disinfection in UV reactors.
Clicks: 188
ID: 87060
2019
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Steady Performance
30.0
/100
188 views
34 readers
AI Quality Assessment
Not analyzed
Readership in this journal
SteadyRanked #52 of 69 articles by views in water science and technology : a journal of the international association on water pollution research
Most read
Least read
Bar heights use a square-root scale.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
Performance of UV reactors for water disinfection is investigated in this paper. Both experimental and numerical studies are performed on base reactor LP24. Enterobacteria phage MS2 is chosen as the challenge microorganism in the experiments. Experiments are conducted to evaluate the effect of different parameters, i.e. flow rate and UV transmission, on the reactor performance. Simulation is carried out based on the commercial software ANSYS FLUENT with user defined functions (UDFs) implemented. The UDF is programmed to calculate UV dose absorbed by different microorganisms along their flow trajectories. The effect with boundary layer mesh and without boundary layer mesh for LP24 is studied. The results show that the inclusion of boundary layer mesh does not have much effect on the reactor performance in terms of reduction equivalent dose (RED). The numerical results agree well with the experimental measurements, hence validating the numerical model. With this achieved, the numerical model is applied to study other scaled reactors: LP12, LP40, LP60 and LP80. Comparisons show that LP40 has the highest RED and log inactivation among all the reactors while LP80 has the lowest RED and log inactivation.
| Reference Key |
li2019numericalwater
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | Li, H Y;Osman, H;Kang, C W;Ba, T;Lou, J; |
| Journal | water science and technology : a journal of the international association on water pollution research |
| Year | 2019 |
| DOI |
10.2166/wst.2019.394
|
| URL | |
| Keywords | Keywords not found |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.