Aptamer based ratiometric electrochemical sensing of 17β-estradiol using an electrode modified with gold nanoparticles, thionine, and multiwalled carbon nanotubes.

Clicks: 396
ID: 76635
2019
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This article has not been analysed, so there is no overall score — reader engagement is measured and shown alongside.
AI Quality Assessment
Not analyzed
Readership in this journal
Emerging

Ranked #16 of 75 articles by views in Mikrochimica acta

Most read Least read

Bar heights use a square-root scale.

Mint this article as an NFT
Not yet minted

Create a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.

5 SUSD one-off · no wallet required
Sign in to mint
Abstract
Gold nanoparticles (AuNPs) with a size of ~3 nm were placed on a thionine-multiwalled carbon nanotube (Thi-CNTs) conjugate to form a novel AuNP-Thi-CNTs nanocomposite. Its morphology and composition were characterized by transmission electron microscopy, atomic force microscopy, X-ray diffraction, and X-ray photoelectron spectroscopy. The nanocomposite was placed on an electrode and used as a redox-active signaling interface to fabricate a ratiometric electrochemical aptasensor for 17β-estradiol (E2). The potentiostatic insertion method was applied to insert an aptamer against E2 into a thin alkane monolayer to warrant an adequate distance between aptamers. The aptamer against E2 acts as both a collector and separator to specifically bind E2. The electrode displays two peak signals (at +0.50 V vs. SCE for E2; and at -0.32 V for Thi) which increase and decrease, respectively, in the 12 pM to 60 nM E2 concentration range. Therefore, the current ratio can be used to reliably, reproducibly, and sensitively quantify the concentration of E2. Graphical abstract Schematic presentation of a novel AuNP-Thi-CNTs nanocomposite. AuNP-Thi-CNTs showed good electrocatalytic oxidation to E2. AuNP-Thi-CNTs was used as self-redox signal interface to fabricate aptasensor. Dual signals of extrinsic E2 and inner Thi was applied to monitor the concentration of E2.
Reference Key
liu2019aptamermikrochimica Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors Liu, Xinyan;Deng, Keqin;Wang, Hao;Li, Chunxiang;Zhang, Shaowei;Huang, Haowen;
Journal Mikrochimica acta
Year 2019
DOI
10.1007/s00604-019-3465-y
URL
Keywords
Cyclic voltammetry differential pulse voltammetry 17β-estradiol detection potentiostatic-insertion method ratiometric electrochemical aptasensor

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

Comments

No comments yet. Be the first to comment on this article.