Enhancing the antibacterial efficacy of low-dose gentamicin with 5 minute assistance of photothermy at 50 °C.

Clicks: 298
ID: 76268
2019
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This article has not been analysed, so there is no overall score — reader engagement is measured and shown alongside.
AI Quality Assessment
Not analyzed
Readership in this journal
Emerging

Ranked #16 of 36 articles by views in Biomaterials science

Most read Least read

Bar heights use a square-root scale.

Mint this article as an NFT
Not yet minted

Create a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.

5 SUSD one-off · no wallet required
Sign in to mint
Abstract
Implant materials are prone to bacterial infections and cause serious consequences, while traditional antibiotic therapy has a long treatment cycle and even causes bacterial resistance. In this work, a photothermal therapy (PTT) assisted drug release system has been developed on the implant surface for in situ rapid disinfection under 808 nm light irradiation within a short time, in which gentamicin (Gent) is loaded by polyethylene glycol (PEG) modified molybdenum disulfide (MoS2) on Ti surface, and then encapsulated with chitosan (CS) (CS/Gent/PEG/MoS2-Ti). The hyperthermia produced by the coatings irradiated by 808 nm near-infrared (NIR) light can not only accelerate the local release of Gent, but also reduce the activity of bacteria, which makes it easy for these locally released drugs to enter the interior of the bacteria to inhibit the protein synthesis and destroy the cell membrane. When maintained at 50 °C for 5 min under NIR irradiation, this system can achieve an antibacterial efficacy of 99.93% and 99.19% against Escherichia coli and Staphylococcus aureus, respectively. By contrast, even after treatment for 120 min, only a 93.79% antibacterial ratio can be obtained for Gent alone. This is because hyperthermia produced from the coatings during irradiation can assist antibiotics in killing bacteria in a short time. Even under a low dose of 2 μg mL-1, the photothermal effect assisted gentamicin can achieve an antibacterial efficacy of 96.86% within 5 min. In vitro cell culture shows that the modified surface can facilitate cell adhesion, spreading and proliferation. The 7 day subcutaneous infection model confirms that the prepared surface system can exhibit a much faster sterilization and tissue reconstruction than the control group with light assistance. Compared with the traditional drug release system, this photothermy controlled drug-loaded implant surface system can not only provide rapid and high-efficiency in situ sterilization, but also offer long-term prevention of local bacterial infection.
Reference Key
ma2019enhancingbiomaterials Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors Ma, Mengxue;Liu, Xiangmei;Tan, Lei;Cui, Zhenduo;Yang, Xianjin;Liang, Yanqin;Li, Zhaoyang;Zheng, Yufeng;Yeung, Kelvin Wai Kwok;Wu, Shuilin;
Journal Biomaterials science
Year 2019
DOI
10.1039/c8bm01539b
URL
Keywords
aliquat 336 polymer inclusion membrane thermal-compression technique thermoplastic polymers

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

Comments

No comments yet. Be the first to comment on this article.