Tritium speciation in nuclear reactor bioshield concrete and its impact on accurate analysis.
Clicks: 335
ID: 76230
2008
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Steady Performance
66.2
/100
335 views
206 readers
Trending
AI Quality Assessment
Not analyzed
Readership in this journal
SteadyRanked #28 of 194 articles by views in Analytical chemistry
Most read
Least read
Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 194 in total.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
Tritium ((3)H) is produced in nuclear reactors via several neutron-induced reactions [(2)H(n, gamma)(3)H, (6)Li(n, alpha)(3)H, (10)B(n, 2alpha)(3)H, (14)N(n, (3)H)(12)C, and ternary fission (fission yield <0.01%)]. Typically, (3)H is present as tritiated water (HTO) and can become adsorbed into structural concrete from the surface inward where it will be held in a weakly bound form. However, a systematic analysis of a sequence of subsamples taken from a reactor bioshield using combustion and liquid scintillation analysis has identified two forms of (3)H, one weakly bound and one strongly bound. The strongly bound tritium, which originates from neutron capture on trace lithium ((6)Li) within mineral phases, requires temperatures in excess of 350 degrees C to achieve quantitative recovery. The weakly bound form of tritium can be liberated at significantly lower temperatures (100 degrees C) as HTO and is associated with dehydration of hydrous mineral components. Without an appreciation that two forms of tritium can exist in reactor bioshields, the (3)H content of samples may be severely underestimated using conventional analytical approaches. These findings exemplify the need to develop robust radioactive waste characterization procedures in support of nuclear decommissioning programs.
Abstract Quality Issue:
This abstract appears to be incomplete or contains metadata (32 words).
Try re-searching for a better abstract.
| Reference Key |
kim2008tritiumanalytical
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | Kim, Dae Ji;E Warwick, Phillip;Croudace, Ian W; |
| Journal | Analytical chemistry |
| Year | 2008 |
| DOI |
10.1021/ac8002787
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.