Wearable 1 V operating thin-film transistors with solution-processed metal-oxide semiconductor and dielectric films fabricated by deep ultra-violet photo annealing at low temperature

Clicks: 279
ID: 66595
2019
Free PDF
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This article has not been analysed, so there is no overall score — reader engagement is measured and shown alongside.
AI Quality Assessment
Not analyzed
Readership in this journal
Steady

Ranked #550 of 1,628 articles by views in Scientific reports

Most read Least read

Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 1,628 in total.

Mint this article as an NFT
Not yet minted

Create a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.

5 SUSD one-off · no wallet required
Sign in to mint
Abstract
Abstract Amorphous metal-oxide semiconductors (AOSs) such as indium-gallium-zinc-oxide (IGZO) as an active channel have attracted substantial interests with regard to high-performance thin-film transistors (TFTs). Recently, intensive and extensive studies of flexible and/or wearable AOS-based TFTs fabricated by solution-process have been reported for emerging approaches based on device configuration and fabrication process. However, several challenges pertaining to practical and effective solution-process technologies remain to be resolved before low-power consuming AOS-based TFTs for wearable electronics can be realized. In this paper, we investigate the non-thermal annealing processes for sol-gel based metal-oxide semiconductor and dielectric films fabricated by deep ultraviolet (DUV) photo and microwave annealing at low temperature, compared to the conventional thermal annealing at high temperature. A comprehensive investigation including a comparative analysis of the effects of DUV photo and microwave annealing on the degree of metal-oxide-metal networks in amorphous IGZO and high-dielectric-constant (high-k) aluminum oxide (Al2O3) films and device performance of IGZO-TFTs in a comparison with conventional thermal annealing at 400 °C was conducted. We also demonstrate the feasibility of wearable IGZO-TFTs with Al2O3 dielectrics on solution-processed polyimide films exhibiting a high on/off current ratio of 5 × 104 and field effect mobility up to 1.5 cm2/V-s operating at 1 V. In order to reduce the health risk and power consumption during the operation of wearable electronics, the operating voltage of IGZO-TFTs fabricated by non-thermal annealing at low temperature was set below ~1 V. The mechanical stability of wearable IGZO-TFTs fabricated by an all-solution-process except metal electrodes, against cyclic bending tests with diverse radius of curvatures in real-time was investigated. Highly stable and robust flexible IGZO-TFTs without passivation films were achieved even under continuous flexing with a curvature radius of 12 mm.
Reference Key
yu2019wearablescientific Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors Yu, Byoung-Soo;Jeon, Jun-Young;Kang, Byeong-Cheol;Lee, Woobin;Kim, Yong-Hoon;Ha, Tae-Jun;
Journal Scientific reports
Year 2019
DOI
DOI not found
URL
http://link.springer.com/article/10.1038/s41598-019-44948-z
Keywords
Medicine Materials of engineering and construction. Mechanics of materials Chemical technology Technology Science (General) Science physics

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

Comments

No comments yet. Be the first to comment on this article.