Intensity of quartz-tungsten-halogen light polymerization units used in dental offices in Brazil.

Clicks: 347
ID: 46575
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This article has not been analysed, so there is no overall score — reader engagement is measured and shown alongside.
AI Quality Assessment
Not analyzed
Readership in this journal
Steady

Ranked #2 of 3 articles by views in the international journal of prosthodontics

Most read Least read

Bar heights use a square-root scale.

Mint this article as an NFT
Not yet minted

Create a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.

5 SUSD one-off · no wallet required
Sign in to mint
Abstract
To determine the intensity of quartz-tungsten-halogen light polymerization units in dental offices in El Salvador, Brazil.A team of researchers visited 100 offices in 2003. The team measured light intensity with a radiometer. The age and make of the units and the availability of light meters were recorded.One hundred twenty quartz-tungsten-halogen units were tested. Intensity ranged from 10 to 1,000 mW/cm2, with mean of 255.8 mW/cm2. Almost half (48%) of the units had values equal to or less than 200 mW/cm2. Their age ranged from 1 to 21 years. None of the offices had light meters.Clinicians should periodically monitor light intensity and carry out maintenance on their light polymerization units.
Reference Key
santosintensitythe Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors Santos, Gildo Coelho;Santos, Maria Jacinta Moraes Coelho;El-Mowafy, Omar;El-Badrawy, Wafa;
Journal the international journal of prosthodontics
Year Year not found
DOI
DOI not found
URL URL not found
Keywords
hardness dental offices irradiance light output light-curing units radiometers

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

Comments

No comments yet. Be the first to comment on this article.