Death is in the air: Confirmation of decomposition without a corpse.

Clicks: 188
ID: 34185
2019
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This article has not been analysed, so there is no overall score — reader engagement is measured and shown alongside.
AI Quality Assessment
Not analyzed
Readership in this journal
Emerging

Ranked #106 of 132 articles by views in forensic science international

Most read Least read

Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 132 in total.

Mint this article as an NFT
Not yet minted

Create a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.

5 SUSD one-off · no wallet required
Abstract
This case report summarises the investigation of a death scene in the trunk of a car. Air sampling, laser-induced breakdown spectroscopy, and gas chromatography/mass spectrometry on samples of carpet and tyre well scrapings from the vehicle's trunk were utilised to confirm the presence of a human decompositional event even though no human remains were discovered in the vehicle. Air sampling has been used in numerous industries for many decades, but only recently has been applied to forensic investigations although it has been at the centre of controversy over the use of this technique in such cases. This report also describes the value of such investigative tools and points to the discovery of evidence, which, without the use of these techniques, would not have been identified.
Reference Key
vass2019deathforensic Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors Vass, Arpad A;
Journal forensic science international
Year 2019
DOI
S0379-0738(19)30182-3
URL
Keywords Keywords not found

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

No comments yet. Be the first to comment on this article.