Nitrogen-doped carbon-based electrocatalysts synthesised by ball-milling

Clicks: 275
ID: 31484
2018
Free PDF
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This article has not been analysed, so there is no overall score — reader engagement is measured and shown alongside.
AI Quality Assessment
Not analyzed
Readership in this journal
Emerging

Ranked #44 of 71 articles by views in electrochemistry communications

Most read Least read

Bar heights use a square-root scale.

Mint this article as an NFT
Not yet minted

Create a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.

5 SUSD one-off · no wallet required
Abstract
Herein, for the first time, ball-milling of carbon materials (e.g. graphite, graphene oxide or graphene) in the presence of dicyandiamide (DCDA) followed by heat treatment at 800 °C was employed to synthesise N-doped carbons for the oxygen reduction reaction (ORR) in alkaline medium. The obtained results highlight that: i) the N-doped nanocarbon catalysts synthesis process employed herein is easy and could be used without hazardous solvents; ii) X-ray photoelectron spectroscopy indicated successful N-doping, iii) N-doped graphite and graphene are Mn-free as confirmed by the ICP-MS analysis, iv) the ORR electrocatalytic activity depends on the carbon source used for the catalyst preparation and v) all the N-doped nanocarbons revealed better ORR performance than the undoped materials. Keywords: Ball-milling, Graphene, Oxygen reduction, Nitrogen-doping, Electrocatalysis
Reference Key
sibul2018nitrogendopedelectrochemistry Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors
Journal electrochemistry communications
Year 2018
DOI
DOI not found
URL
Keywords Keywords not found

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

No comments yet. Be the first to comment on this article.