Energy modeling, fabrication and evaluation of a small-scale natural convection solar dryer for microalgae biofuel production
Clicks: 5
ID: 286997
2011
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Popular Article
1.2
/100
5 views
2 readers
AI Quality Assessment
Not analyzed
Readership in this journal
PopularRanked #248 of 3,757 articles by views in Malay Journal
Most read
Least read
Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 3,757 in total.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
One of the most promising sources of biofuel is microalgae. Microalgae are unicellular photosynthetic organisms that have a high photosynthetic efficiency (10 to 20%) compared to other plant species (0.5%) (Huntley, et al., 2007). However, the large initial moisture content of microalgae (80 to 90%, wet-basis) causes problems during oil extraction. According to Halim, et al. (2011), the lipid yield of dried microalgae is 33% higher than wet microalgae using hexane extraction. The study aims to predict the drying performance of microalgae biomass as a function of solar dryer design. The best combination of direct radiation, convective heat input and air flow rate was determined. A computational model for predicting the drying air temperature and relative humidity was solved using a spreadsheet program. The results of both models were validated by means of actual experimentation with a fabricated solar dryer and ANSYS Computational Fluid Dynamics simulation. Statistical analysis of the results showed that direct radiation (Qr) is more efficient than the convective heat input in increasing the drying rate. Qr allows the biomass surface temperature to get over the drying airs wet bulb temperature, giving rise to a significant increase in the drying rate. High air velocity results to inefficient drying. The computational model predicted the temperature and relative humidity of the drying air with an error percentage of 4.3% and 11.8%, respectively. ANSYS-CFD simulation was congruent with the assumptions used in the computational model. The regression equation generated from the characterization experiment was able to predict the average drying rate with an error percentage of 10%. The computational model was able to predict the temperatures and relative humidity of the drying chamber with an error percentage of 4.3% and 11.8%, respectively. Overall, the results show that drying rate is maximum at low air flow rate, high direct radiation and high convective heat input. Also, based on the measured available energy inside the solar dryer from actual experimentations, a microalgae dry mass yield of 800g/m2-hr which will be able to produce 180mL of oil per hour on a good sunny day was computed.
| Reference Key |
persistent_1760660286_68f18b3e24759
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | Lopez, Neil Stephen A. |
| Journal | Malay Journal |
| Year | 2011 |
| DOI |
DOI not found
|
| URL | |
| Keywords | Keywords not found |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.