Design and fabrication of a pneumatic pick and place cylindrical robot for machine load and unload
Clicks: 1
ID: 286719
1992
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
0.0
/100
1 views
0 readers
AI Quality Assessment
Not analyzed
Readership in this journal
Ranked #3,589 of 3,757 articles by views in Malay Journal
Most read
Least read
Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 3,757 in total.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
This introduces into the Philippine plastic manufacturing industry a pneumatic pick and place robot that uses electronic controllers, pneumatic cylinders, and materials readily available in the local market. The robot was designed for a pick and place application in a plastic molding machine where the robot will unload the products. The results show that the operating cycle time was recorded at seven (7) seconds which means the robot is competitive with the five (5) to seven (7) second cycle time of similar commercial robots.
| Reference Key |
persistent_1760659436_68f187ece358f
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | Bugtai, Nilo T. |
| Journal | Malay Journal |
| Year | 1992 |
| DOI |
DOI not found
|
| URL | |
| Keywords | Keywords not found |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.