Retrofitting computer numerical control to conventional lathe machine : a simulated approach
Clicks: 7
ID: 286717
1994
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Emerging Content
1.8
/100
7 views
6 readers
AI Quality Assessment
Not analyzed
Readership in this journal
EmergingRanked #2,671 of 3,757 articles by views in Malay Journal
Most read
Least read
Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 3,757 in total.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
The machine tool is our most valuable aid in the manufacture of industrial goods. With the international situation as it is today, the quality and quantity of the goods are economically and even politically important factors in determining the status of the national economy. This fact alone is a sufficient confirmation that the machine tool is holding a key position. Today the Philippines has to import CNC or numerical controlled machines at a very expensive price (normally in millions of pesos) from other countries like Japan and Europe. There has been hardly any attempt taken in the development of CNC machines in the country. Thus, if we can make our own CNC machines, this would remove the need to import them. The project, though basic, is a powerful typical CNC program. A properly designed control system with a software-hardware link will control the movement of the lathe machine. The signals to be transmitted are programmed with the use of a simulation software written in C++. The software will allow the user to manipulate the lathe machine by inputting various parameters, such as position, codes and speed. The program likewise simulates the actual machine operations and consequently tests and runs it. The project aims to provide CNC capabilities to conventional lathe machines. In this way an economical skip is made to high technology and global competitiveness.
| Reference Key |
persistent_1760659431_68f187e72aa92
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | Garcia, Gregg R. |
| Journal | Malay Journal |
| Year | 1994 |
| DOI |
DOI not found
|
| URL | |
| Keywords | Keywords not found |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.