Retrofitting of asynchronous transfer system for manufacturing cell integration
Clicks: 3
ID: 286685
2010
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Popular Article
0.6
/100
3 views
0 readers
AI Quality Assessment
Not analyzed
Readership in this journal
PopularRanked #3,363 of 3,757 articles by views in Malay Journal
Most read
Least read
Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 3,757 in total.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
Automation is one of the thrusts of the Mechatronics Engineering (MEE) and Manufacturing Engineering & Management (MEM) department of Bulacan State University (BulSU) that is why a great part of the curriculum is devoted towards studying the building blocks of automated system for industries. Since engineering education requires experimentation, the university invested on several stand-alone automation laboratory equipment's, in order for its graduates to have an adequate knowledge in the equipment's used in the industry. Todays industries rely on the cooperative development of multidisciplinary technical systems and most manufacturing process is integrated with robotics, conveyors, sensors and programmable logic controllers. With the present set up of the industries, integrated manufacturing systems such as Manufacturing Cell, Flexible Manufacturing System (FMS) and Computer Integrated Manufacturing (CIM) system are needed in order to provide the industries with skilled manpower. Also, if manufacturing systems could be brought into the laboratories of academic institutions, manufacturing training, design, experimentation, and testing could be significantly enhanced. The research design used in the study was experimental method. The designs, manufacture, assembly, testing and technical documentations were done with the guide of various tools such as MS Office, Automation Studio, Microsoft Visio, WinSPS, Hyperterminal, and SNC software. Experimental set-up was used to test iv the functionality of the system. Efficiency rating will be considered as determinant for the acceptability of the system. The non functional Automated Transfer System has been reconfigured and integrated to the Manufacturing cell. The RV 500 robots gripper has been upgraded to a pneumatic one. A CNC Engraver has been produced from an XY table and a Z axis. The Manufacturing cell has been integrated by means of a PLC that acted as Cell Controller.
| Reference Key |
persistent_1760659337_68f1878985967
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | Jimenez, Nasher Guevarra |
| Journal | Malay Journal |
| Year | 2010 |
| DOI |
DOI not found
|
| URL | |
| Keywords | Keywords not found |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.