Analysis of Ground Feed in a Drum Grinder

Clicks: 62
ID: 275751
2022
Free PDF
Article Quality & Performance Metrics
Overall Quality Improving Quality
0.0 /100
Combines engagement data with AI-assessed academic quality
AI Quality Assessment
Not analyzed
Abstract
In Uzbekistan, special attention is paid to the development of livestock, poultry and fish farming. In the ration of animals, green fodder obtained by cutting green stalks corn, alfalfa and other feed crops has a special place. For high-quality chopping of stalks with the required cutting length for each type of animal, a chopper has been developed with a simple design for chopping green feed.Testing of the chopper work, carried out at an engine speed of 2800 rpm, a cutting drum rotation speed of 950 rpm and in two rotations of the feed rollers 10 rpm and 20 rpm with an average length of alfalfa stalks 71.6 cm and an average length of corn stalks 216.4 cm, showed that at a feed roller rotation speed of 10 rpm the average cutting length of the stalks was 10.6 mm, and at a feed roller rotation speed of 20 rpm - 17.6 mm. It can be seen from the data that with a twice increase in the feed roll speed, the cutting length increases 1.66 times, which confirms the theoretical assumptions obtained.
Reference Key
Atkham2022internationalAnalysis Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors Borotov Atkham;Baimakhanov Kenzhemirza;
Journal International Journal of Biological Engineering and Agriculture
Year 2022
DOI
412
URL
https://inter-publishing.com/index.php/IJBEA/article/view/412
Keywords
knife stalks chopper cutting drum drum speed cutting length

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

Comments

No comments yet. Be the first to comment on this article.