Revisiting the loading dose of amikacin for patients with severe sepsis and septic shock - Critical Care
Clicks: 324
ID: 273343
2010
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Steady Performance
30.0
/100
324 views
60 readers
AI Quality Assessment
Not analyzed
Readership in this journal
SteadyRanked #1 of 17 articles by views in critical care
Most read
Least read
Bar heights use a square-root scale.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
Introduction It has been proposed that doses of amikacin of >15 mg/kg should be used in conditions associated with an increased volume of distribution (Vd), such as severe sepsis and septic shock. The primary aim of this study was to determine whether 25 mg/kg (total body weight) of amikacin is an adequate loading dose for these patients. Methods This was an open, prospective, multicenter study in four Belgian intensive care units (ICUs). All consecutive patients with a diagnosis of severe sepsis or septic shock, in whom amikacin treatment was indicated, were included in the study. Results In 74 patients, serum samples were collected before (t = 0 h) and 1 hour (peak), 1 hour 30 minutes, 4 hours 30 minutes, 8 hours, and 24 hours after the first dose of amikacin. Blood amikacin levels were measured by using a validated fluorescence polarization immunoassay method, and an open two-compartment model with first-order elimination was fitted to concentrations-versus-time data for amikacin (WinNonlin). In 52 (70%) patients, peak serum concentrations were >64 μg/ml, which corresponds to 8 times the clinical minimal inhibitory concentration (MIC) breakpoints defined by EUCAST for Enterobacteriaceae and Pseudomonas aeruginosa (S16 μg/ml). Vd was 0.41 (0.29 to 0.51) L/kg; elimination half-life, 4.6 (3.2 to 7.8) hours; and total clearance, 1.98 (1.28 to 3.54) ml/min/kg. No correlation was found between the amikacin peak and any clinical or hemodynamic variable. Conclusions As patients with severe sepsis and septic shock have an increased Vd, a first dose of ≥ 25 mg/kg (total body weight) of amikacin is required to reach therapeutic peak concentrations. However, even with this higher amikacin dose, the peak concentration remained below therapeutic target levels in about one third of these patients. Optimizing aminoglycoside therapy should be achieved by tight serum-concentration monitoring because of the wide interindividual variability of pharmacokinetic abnormalities.
| Reference Key |
silvio2010criticalrevisiting
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | Taccone, Fabio Silvio;Laterre, Pierre-François;Spapen, Herbert;Dugernier, Thierry;Delattre, Isabelle;Layeux, Brice;De Backer, Daniel;Wittebole, Xavier;Wallemacq, Pierre;Vincent, Jean-Louis;Jacobs, Frédérique;Taccone, Fabio Silvio;Laterre, Pierre-François;Spapen, Herbert;Dugernier, Thierry;Delattre, Isabelle;Layeux, Brice;De Backer, Daniel;Wittebole, Xavier;Wallemacq, Pierre;Vincent, Jean-Louis;Jacobs, Frédérique; |
| Journal | critical care |
| Year | 2010 |
| DOI |
doi:10.1186/cc8945
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.