Development of scanning technique for sTGC detectors production quality control

Clicks: 215
ID: 272741
2016
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This article has not been analysed, so there is no overall score — reader engagement is measured and shown alongside.
AI Quality Assessment
Not analyzed
Readership in this journal
Steady

Ranked #493 of 935 articles by views in journal of physics: conference series

Most read Least read

Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 935 in total.

Mint this article as an NFT
Not yet minted

Create a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.

5 SUSD one-off · no wallet required
Abstract
The innermost station of the ATLAS muon end-cap system will be replaced during the forthcoming Phase-I upgrade of the ATLAS detector. The small-strip Thin Gap Chambers (sTGC) are supposed to operate at harsh radiation conditions of super LHC. X-ray scanning technique for production quality control is proposed to ensure long-term reliability of these chambers. It allows to reveal different types of technological defects critical for sTGC chambers operation.
Reference Key
vorobev2016journaldevelopment Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors Peter Teterin,K A Filippov,S P Konovalov,G Mikenberg,A Romaniouk,D Shchukin,M Shoa,V Smakhtin,Sergei Smirnov,V V Sosnovtsev,V O Tikhomirov,V I Tsekhosh,K A Vorobev;Peter Teterin;K A Filippov;S P Konovalov;G Mikenberg;A Romaniouk;D Shchukin;M Shoa;V Smakhtin;Sergei Smirnov;V V Sosnovtsev;V O Tikhomirov;V I Tsekhosh;K A Vorobev;
Journal journal of physics: conference series
Year 2016
DOI
10.1088/1742-6596/675/1/012015
URL
Keywords

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

No comments yet. Be the first to comment on this article.